Get Quote

Custom Rubber Product Samples

Custom Rubber Corp.

Molded Rubber Hinge Cover with PSA

Custom Rubber Corp. has the capability to apply PSA (pressure sensitive adhesive) to rubber products in various shapes, sizes, and configurations; whether the rubber part is die-cut, extruded, or molded Custom Rubber Corp.

Pictured below is a molded rubber hinger cover, with a pressure sensitive adhesive. Used on the back door of an automobile, adhesion was critical for this molded rubber hinge cover. (Continued below.)

Rubber Molding Custom Rubber
(ref. 105636)

The molded rubber hinge cover acts as a spacer between the glass and the spoiler on the rear deck of a car. Both sides of the rubber hinge cover's flange act as a sealing surface, with PSA applied to one side of the molded rubber part. Custom Rubber Corp. used their rubber molding expertise to select the right combination of pressure sensitive adhesive and non-blooming rubber to ensure the PSA would adhere securely to the rubber. The final molded rubber hinge cover, applied with PSA, fit the customer's application perfectly.

If you have an application that requires a rubber part with PSA, contact Custom Rubber Corp. today

The rubber parts pictured are not in stock or for sale. These are examples of custom-manufactured rubber molded products that illustrate Custom Rubber Corp.'s rubber molding capabilities.

See other round gasket and seal products.


Custom Rubber Corp. 1274 E. 55th Street, Cleveland, OH 44103-1029© Custom Rubber Corp. All rights reserved.
Phone: 216-391-2928   Fax: 216-391-4761   sales@customrubbercorp.com